I am having to replace my Hitec HS - 700 BB 1/4 turret drive servo on my 1/6 Mark - 1 Tiger 1 as a result of sheared servo cog teeth ( I think thats what they're called.. )
I'm thinking about replacing it with a Hitec 705 MG servo but on examining the old servo, there have been additional wires inserted into the servo which are just dangling to the side . Is this some kind of pick up / antenna / safety addition ?
All I know id that the new servos certainly do not have these pictured on them so I can only assume it serves some purpose other than functioning as a servo !
Apologies for my lack of knowledge once again, but I'd really appreciate if someone could explain what these additional wires are for, and more to the point, whether I can simply replace the old Hitec HS - 700BB with the newer Hitec 705 MG servo without adding whatever the old additional wires finctionality was !.
Thanks again for your advice guys....
UKTC European Coordinator
They shall not grow old as we who are left grow old.
Age shall not weary them, nor the years condemn.
At the going down of the sun and in the morning,
WE WILL REMEMBER THEM.
Hi.....rivetcounter wrote:John, the servo is modified to turn 360 degrees as opposed to the standard 45, best thing to do is as always give Mark 1 Tanks a call he will be able to supply a modified servo that you can bolt straight into your tank.
Great....thanks for the advice
Who is online
Users browsing this forum: No registered users and 2 guests