Glue removal

For the serious discussion of RC Tank building and general engineering matters.

Moderator: Moderators

Post Reply
Posts: 447
Joined: Fri Oct 20, 2006 9:30 pm

Glue removal

Post by saracen » Sun Aug 29, 2010 12:52 pm

Does anyone have any tips for removing epoxy adhesive from Armortek Tiger tyres ?

I think most of it actually stayed with the wheels but there is some on some tyres. Nitromors paint stripper might be a bit harsh for the tyres, though I'll try a small section this morning, and obviously a heat gun is out :shock:

Or do I just take the view that, as it was stuck well enough not to come off when I pulled the tyres from the wheels, it should be OK to take the next adhesive when I stick them back on again ?


User avatar
Vixen V8
Posts: 154
Joined: Mon Jan 25, 2010 10:34 pm
Location: Fareham, Hampshire, UK

Re: Glue removal

Post by Vixen V8 » Sun Aug 29, 2010 4:46 pm

Hello Adrian,
If most of the epoxy stayed with the wheels then it obviously does not want to stick well to the rubber tyres. Try flexing the rubber to break the remaining adhesion and help the remaining stuff of with a bluntish knife blade, scrape it off, not cut it off.
Try to avoid solvents, they will probably attack the rubber before the epoxy.

t90 bestintheworld
Posts: 191
Joined: Fri Feb 27, 2009 7:24 pm
Location: newpark, ibiza

Re: Glue removal

Post by t90 bestintheworld » Thu Sep 09, 2010 7:10 am

hi there.
you could always try epoxy remover.
lots to pick from on the interweb.
all the best

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest